Inserting the sawed part... looks OK ! :)

[ Sizes: Orig | Large | Med | Small | Thumb ]

Comments

[ Post a Comment ]

Viewing: 1-2 of 2

Baarb

Are you

Hasn't voted

indicating the extent of the piece you put in? How do you get it all the way down if it is a tight fit and the hammer is only useful at the beginning?

Posted Dec 2, 2011 9:23 pm


	Visentin	Re: Are you
	Hasn't voted	Yep, the position of the part. Before I did it, it was all mystery. I was afraid the part would fall at the bottom due to wider diameter and being unable to get it back. Or, opposite, not managing to get it till the level I was seeking. Surprisingly all went fine, it moved down smoothly, I had to hit gently the iron tube I used as a burin. Near the position I seeked it went harder and harder, but it reached it at the right moment. I think I had a great intuition and above all I was very lucky it went all fine.
		Posted Dec 3, 2011 7:20 am